133 Millimetres: The Dimension Your Whole Freezer Is Built Around

There is one number behind the design of almost every mechanical freezer rack, drawer system and vapour phase shelf in use: 133 x 133 mm. Roughly 5.25 inches square. It is the cryobox footprint, and it is the reason boxes from different sources usually drop into the same rack.
Height is where it goes wrong
The footprint is settled. Height is not, and the vial sets it rather than preference:
- 25 mm for 0.5 mL microtubes and low profile tubes
- 50 to 52 mm for 1.0 to 2.0 mL cryogenic vials, the default in cell banking
- 75 mm for 4 to 5 mL vials
- 95 to 100 mm for tall and specialist formats, check rack clearance first
Measure the vial with the cap fitted. The cap is what fouls the lid and the cap is what gets missed. And a box slightly too tall does not simply sit proud: in a drawer system it stops the drawer closing fully, which breaks the seal and raises the temperature of every sample on that shelf.
Same square, four capacities
Inside that footprint the grid divider decides everything: 100 positions at 10 x 10, 81 at 9 x 9, 36 at 6 x 6, 25 at 5 x 5. Across a rack of five boxes that is 500, 405, 180 or 125 vials. Density is not free, though. The 100 position box gains 23 per cent over the 81, and loses it again in retrieval time at the open neck of a vessel with gloved hands.
The material decides how it fails
Polycarbonate is commonly specified to around -86 degrees C and becomes brittle below it. Coated board is commonly rated to -196 degrees C but absorbs moisture and sticks in the rack. Neither belongs in liquid phase, where a box fills with liquid nitrogen and a poorly sealed vial takes it inside.
Full guide: Cryoboxes and cryogenic freezer boxes
Comments
Post a Comment